Place the mower on a level surface. Locate the lever handles between each wheel and the mower deck. Pull up on one lever handle, and push the handle toward the wheel. Move the handle up or down to adjust the height of the deck.
How do you adjust the height of a push mower?
Pull the height adjustment lever outward toward the wheel on an electric mower. Move the lever to a higher number to the rear of the deck for a longer cutting height. Adjust the lever to the front of the deck to a lower number for a shorter cutting height. All four wheels adjust with one lever on most electric models.
How do you adjust the handle on a Toro lawn mower?
Attention; read the Operator’s Manual—1) Loosen the knob by turning it counterclockwise; 2) Pull the cable(s) away from the engine to decrease the traction, or push the cable(s) toward the engine to increase the traction; 3) Tighten the knob by turning it clockwise.
Should lawn mower wheels be same height?
Lawn mower wheels should be the same height, sitting between 2.5 to 3.5 inches (6.4 to 8.9 cm). The reason that some mowers are tilted forward is that the deck is sloped, not the wheels. A tilted deck offers more control on flat surfaces, and it prevents grass clippings from blowing around the yard.
Is a push mower deck height supposed to be the same at the front and back?
For most effective results, a lawn mower deck should have a pitch, or height difference of 1/8-inch to 1/2-inch between the front of the deck to the back of the deck. … Be careful not to pitch too much that you start scalping lawns.
What setting should my lawn mower be on?
Most homeowners don’t know the height of the lawn mower settings and think the highest setting must be too tall and the lowest setting must be too low, therefore the best setting is the middle setting on the lawn mower. The middle setting is the WRONG setting and is typically way to short.
When should I raise the height of my lawnmower?
A height of two inches is fine when grasses are rapidly growing, but the height should be raised as growth slows, stress increases, and when the lawn is in shade. Lawns should be mowed according to the rate of grass growth; remember not to remove more than one-third of the grass leaf in any one cutting.
What is the highest setting on a lawn mower?
The highest setting on your mower! The top setting for most mowers gives a cutting height between 3.25 and 4 inches. This is best for your lawn, but at a setting of 4 inches you may sometimes see some “laying-over” of turf blades that some people find undesirable.
How do I adjust the blade on my Toro lawn mower?
Move the cutting height lever on one of the front wheels forward to lower the cutting height at that wheel or backward to raise it. You may have to push or pull the lever slightly in order to slide it into the desired position.
Should your mower deck be level?
For most effective results, a lawn mower deck should have a pitch of 1/8-inch to 1/2-inch between the height of the deck rear to the height of the deck front. … In any case, the front of the deck needs to be pitched lower than the deck rear, but don’t pitch too much because deck pitch that’s too steep can scalp lawns.
What is the advantage of large rear wheels on a lawn mower?
High rear wheels.
Manufacturers of high-wheeled mowers situate the engine (or motor, for electric models) more forward to accommodate the greater diameter of the rear wheels. This makes the mower noticeably heavier to tip back for turning, which you do frequently. They require more effort to mow, not less.
When should I lower my lawn mower blade?
For the last mowing or two of fall, simply lower your blades one notch, or set the blades at the lowest mowing height recommended for your grass type. In spring, leave your mower blades at the lower setting for the first couple of mowings, then return the blades to the higher setting for the summer.