|Ford 8N Power:|
|Drawbar (claimed):||23.16 hp [17.3 kW]|
|PTO (claimed):||27.32 hp [20.4 kW]|
|Drawbar (tested):||21.95 hp [16.4 kW]|
|PTO (tested):||23.24 hp [17.3 kW]|
How many horsepower is a Ford 9n tractor?
|Ford 9N Power:|
|Drawbar (claimed):||12.68 hp [9.5 kW]|
|Belt (claimed):||20.29 hp [15.1 kW]|
|Drawbar (tested):||16.31 hp [12.2 kW]|
Are Ford 8N tractors good?
The Ford 8N is the standard of reliability, built to last for generations. While these tractors do require occasional maintenance, there are no significant design flaws that would make this tractor unreliable. These tractors are easy to work on.
How fast does a Ford 8N go?
A 1952 Ford 8N tractor dubbed the “8NCREDIBLE,” has taken the title of world’s fastest farm tractor, reaching a speed of 96.3185 miles per hour.
Which is better Ford 8N or 9n?
They really are basically the same. Only major differences are a couple horsepower, 8n has 4 speed trans and 9n has 3 speed trans. 8n is newer than the 9n and has more hp. Newer 8n have side distributor older 8n’s and 9n’s had front distributor.
What is the difference between an 8N and a 9N Ford tractor?
The most noticeable differences between the 8N and its predecessors was the inclusion of a 4-speed transmission instead of a 3-speed in the 9N and 2N, and an increase in both PTO and drawbar horsepower. The other big change on the 8N was the addition of a ‘Position-control’ setting for the hydraulics.
When did Ford stop making tractors?
Henry Ford and Harry Ferguson.In 1928, Fordson tractor production was halted in the United States, only to be resurrected in 1939 as the Ford Model 9N.
Can a Ford 8N run a tiller?
TILLER: The ‘N’ tractor WILL NOT RUN A TILLER! Unless the tractor is equipped with a rare Howard or Everett auxiliary transmission. The ground speed is simply too fast without it. Another option if you REALLY must use a tiller with an ‘N’ would be a tiller with its own engine.
What is a 8N Ford tractor worth?
You might find a good “clean” 8N with a fresh paint for $1800 or a fully redone one for 5k.
Does Ford 8N tractor have live PTO?
Supporting Member. One disadvantage of the Ford N’s was, they are not Live pto and Live hydraulic. When you push the clutch in, they stop. The mower stops mowing and if it was raised, it lowers to the ground.
Can a Ford 8N pull a 2 bottom plow?
They will not pull a 2 bottom plow and if you are mowing very thick grass with a 5ft. brush hog you are going to have to drive very, very slow.
How much can a Ford 8N lift?
Epic Contributor, R.I.P. Although I could not find the lift capacity at the arms, the Ford 8N operator’s manual says the hydraulic pump produces 1,500 to 1,700 pounds of pressure. I believe you should not have a problem with the 925 lb implement, except for the light front end that you know about.
How much weight can a Ford 8N pull?
Using second gear, at a rated load of 17.43 drawbar horsepower, the 8N pulled 1,753 pounds at 3.73 mph with slippage of 6.73%.
What is the difference between a Ford 8N and a Jubilee?
An 8n has a significantly better power/weight ratio than a Jubilee which may be important if you are going to trailer it. It also has a more durable hydraulic system and considerably better fuel economy as someone has already mentioned.
Is a Ford 9N a good tractor?
The short answer is yes. The 9N is one awful tractor to work compared to an 8N, NAA or later. Not only do you don’t get position control and live hydraulics like on the 8N, both the clutch and left wheel brake are on the left, meaning with the clutch depressed you can only use the right brake.
How do you tell what year a Ford 8N tractor is?
To determine the year of a Ford 8N tractor, the serial number must be located and then compared to a list of serial numbers used by Ford for each of the years in which the tractor was manufactured. Locate the serial number imprinted on the Ford 8N tractor.