Why does my lawn mower start but not stay running?

Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn’t work, you might need a new fuel filter.

Why does my lawn mower only run for a few seconds then dies?

It could be from a dirty carburetor, a malfunctioning spark plug, insufficient flow of gas to the engine or a clogged air filter. But if your lawn mower starts then dies, the causes could also be the same. The most common cause of why a lawn mower starts then dies can be due to a carburetor problem.

How do you fix lawn mower that starts then dies?

This is typically just behind the air filter. Remove the filter, give the hole a spray, then replace the filter. When you start the mower, it’ll be pulled into the engine and clean deposits in your carb.

IT IS INTERESTING:  What oil do I need for my Mountfield lawn mower?

Why does my lawn mower not stay running?

Fuel system problems often cause the engine to stall, so you’ll need to rebuild or replace the carburetor if your lawn mower won’t stay running. … Some engines stall if the gas cap vent gets clogged. Check your mower’s gas cap and clear the vent if it has one.

Why does my mower keep shutting off?

Loss of Air Causing the Mower to Stall

The loss of air flow to the engine caused by too tall or too thick grass or a dirty air filter is often the reason a mower engine stalls. … When you try to mow on overgrown lawn, you end up clogging the air filter and shutting off air to the engine.

How do you fix a lawn mower that won’t stay running?

Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn’t work, you might need a new fuel filter.

Why does my mower only run when I push the primer?

The problem is that the carburetor is restricted or plugged and needs to be cleaned and rebuilt with a COMPLETE carburetor repair kit. Here is my comprehensive carburetor and fuel answer that may give you some ideas. And they call it “Oxygenated fuels! …

How do you clean a carburetor on a lawn mower without removing it?

However, you can not spray the carburetor when the engine is off since it cannot do the cleaning without being propelled. All you need to do is to start the engine and spray directly at the center of the carburetor while it is running. Any deposits clogging in the carburetor will easily be removed.

IT IS INTERESTING:  Quick Answer: Can you just push a self propelled mower?

Why does my lawn mower sputter then die?

A Mower Has to Breathe

Your mower pulls in air from outside and mixes it with gasoline for the proper explosion inside the engine. A dirty air filter inhibits the flow of air into the carburetor. Clean or replace the air filter to stop the mower from sputtering to a halt. … Replace the cap to solve sputtering and dying.

Why does my lawnmower only run on choke?

If your lawn mower only runs with the choke on, check the carburetor. … There are several passages in the carburetor that allow fuel to enter the air stream depending how the throttle is set. The idle circuit, for when the throttle is nearly closed and the engine is idling.

How do I know if my lawnmower spark plug is bad?

A few symptoms provide clues that it’s time to change a spark plug.

  1. Hard Start. The most common problem associated with a bad spark plug in a lawnmower is that the mower is more difficult than normal to start. …
  2. Poor Engine Performance. …
  3. Excessive Fuel Consumption. …
  4. Physical Appearance.

Why does my mower die when I engage the blades?

If a pulley doesn’t spin freely, it can cause the engine to die when the blades are engaged. … The pulleys in your lawn tractor are driven by the drive belt, and turn the spindles. If a pulley doesn’t spin freely, it can cause the engine to die when the blades are engaged.

Efficiency