Best answer: How do you charge a Skyjack scissor lift?

How long does a Skyjack take to charge?

Charging time is approximately 12 hours for the first few charges, 4 hours after the first two full battery cycles, at which point the battery will reach maximum capacity. The lift comes with a battery charger for use in dry locations.

Can you use a scissor lift while charging?

It is important to note that it is possible to use your scissor lift whilst the battery is being charged. All you need to do is pull the red emergency shut-off button out and have a helper guide the extension cord away from the wheels whilst the equipment is moving.

How are scissor lifts powered?

Scissor lifts require linear motion to supply elevation and this force is provided by a pneumatic or hydraulic actuator, or a mechanical input such as a leadscrew or rack and pinion drive. Scissor lifts under fluid power are preferred because a purge valve allows the lift to be lowered during a malfunction.

How long does a scissor lift battery last?

Lifespan depends on battery usage, most batteries last from 6 to 48 months, just 30% of each battery survived this average. A good and lightly used battery can last up to 15 years.

IT IS INTERESTING:  How much does a 26 ft scissor lift weigh?

How do you charge an electric scissor lift?

How to Charge a Scissor Lift

  1. Park the scissor lift in a well ventilated area near an electrical outlet.
  2. Press the emergency shut-off switch to prevent another operator from unknowingly driving away while the lift is plugged in. …
  3. Locate the battery charger on the base of the lift on the right side.

How do you use a Skyjack scissor lift?

How To Operate A Scissor Lift

  1. Pull out the emergency stop button on the control panel.
  2. Select “platform” with off/platform/base select key switch.
  3. Enter the platform.
  4. Pull out the emergency stop button on the platform control panel.
  5. Proceed with job using the required buttons, levers and controller located on the operator console.

How do I turn on Skyjack scissor lift?

How To Operate A Scissor Lift

  1. Pull out the emergency stop button on the control panel.
  2. Select “platform” with off/platform/base select key switch.
  3. Enter the platform.
  4. Pull out the emergency stop button on the platform control panel.
  5. Proceed with job using the required buttons, levers and controller located on the operator console.

How do you charge a JLG 1930es?

DO NOT OPEN OR DISASSEMBLE CHARGER.

Operation

  1. Connect the charger to a grounded outlet. 3-4.
  2. On the battery charger, the charger will automatically. turn on and go through a short LED indicator self-test. All LED’s will flash in sequence for two seconds.
  3. The batteries are fully charged when green light on.

Are scissor lifts safe?

Scissor lifts provide a safe and reliable platform for workers to perform job tasks when used according to the manufacturer’s instructions. When not used properly, scissor lifts can present a serious hazard to workers. Employers are responsible for keeping workers safe.

IT IS INTERESTING:  Best answer: How often should a hoist be checked Loler?

How much weight can a scissor lift lift?

A 19-foot scissor lift with a maximum working height of 25 feet and a lift capacity of 500 pounds will weigh approximately one ton. A 26-foot lift with a maximum platform weight capacity of 800 pounds and a maximum platform height of 25.5 feet can weigh as much as 4,700 pounds.

How much can a scissor lift lift?

Many scissor lifts have an unrestricted weight capacity of approximately 1,000 pounds, and higher restricted weight capacities. The largest, most powerful scissor lifts can hold up to 50 tons of material. These are usually rough terrain hydraulic scissor lifts used in heavy construction.

Can a scissor lift get wet?

Wet conditions mean slippery conditions for both the wheels on your scissor lift hire and for the staff working on them. As most access equipment is made primarily from metals such as steel, when these surface materials get wet, there is very little traction for those on board.

Efficiency