Quick Answer: How long do scissor lifts take to charge?

However, the average time for charging is 12–16 hours and up to 36–48 hours for large batteries. The charger will indicate when the battery is completely charged. When charge cycle is finished, separate the charger plug from the battery tray.

Can you use a scissor lift while charging?

It is important to note that it is possible to use your scissor lift whilst the battery is being charged. All you need to do is pull the red emergency shut-off button out and have a helper guide the extension cord away from the wheels whilst the equipment is moving.

How long does a lift take to charge?

The battery is shipped out of the manufacturer’s facility fully charged, but it will need to be recharged after the first several hours of use. Charging time is approximately 12 hours for the first few charges, 4 hours after the first two full battery cycles, at which point the battery will reach maximum capacity.

How do you charge a scissor lift?

How to Charge a Scissor Lift

  1. Park the scissor lift in a well ventilated area near an electrical outlet.
  2. Press the emergency shut-off switch to prevent another operator from unknowingly driving away while the lift is plugged in. …
  3. Locate the battery charger on the base of the lift on the right side.
IT IS INTERESTING:  Frequent question: What factors can affect the forklifts center of gravity and stability?

Hy-Brid Lifts51 подписчикПодписатьсяScissor Lift Battery & Charger How-To

How long does a scissor lift battery last?

Lifespan depends on battery usage, most batteries last from 6 to 48 months, just 30% of each battery survived this average. A good and lightly used battery can last up to 15 years.

How do you use a Skyjack scissor lift?

How To Operate A Scissor Lift

  1. Pull out the emergency stop button on the control panel.
  2. Select “platform” with off/platform/base select key switch.
  3. Enter the platform.
  4. Pull out the emergency stop button on the platform control panel.
  5. Proceed with job using the required buttons, levers and controller located on the operator console.

How do you charge a JLG 1930es?

DO NOT OPEN OR DISASSEMBLE CHARGER.

Operation

  1. Connect the charger to a grounded outlet. 3-4.
  2. On the battery charger, the charger will automatically. turn on and go through a short LED indicator self-test. All LED’s will flash in sequence for two seconds.
  3. The batteries are fully charged when green light on.

How do you turn on a Skyjack scissor lift?

How To Operate A Scissor Lift

  1. Pull out the emergency stop button on the control panel.
  2. Select “platform” with off/platform/base select key switch.
  3. Enter the platform.
  4. Pull out the emergency stop button on the platform control panel.
  5. Proceed with job using the required buttons, levers and controller located on the operator console.

What do the numbers on a scissor lift mean?

Scissor Lifts Brand Names

With the most popular brands like Genie, Skyjack, JLG, the number in the names of the scissor lifts relates to the width and the height of the machine. Generally, the first two numbers are the platform height, whereas the last two numbers are the width of the machine.

IT IS INTERESTING:  What steps must be done at least daily before using a forklift?
Efficiency